Industry News

What Conditions Do You Need To Meet For Oil-Free Air Compressor Installation?

Views : 4177
Author : Runningway
Update time : 2019-11-15 09:13:32
What conditions do you need to meet for oil-free air compressor installation?

Everyone is an air compressor, but we are different. Water-lubricated oil-free screw air compressor installation process: cooling water tank, automatic water supply, water pump, oil-free screw air compressor, filter, stainless steel gas storage tank, filter, compressed air refrigerating dryer, water filter, Deodorant filter. There are a lot more procedures than the air compressor, and it is necessary to select a suitable equipment place for the water-lubricated oil-free air compressor and recommend the establishment of a special air compressor room. The installation site is required to meet the following requirements:
Oil-free air compressor
1. The air compressor needs to be installed indoors, with excellent lighting, and enough space is reserved for easy operation and maintenance. The air compressor should be separated from the surroundings and ceiling by no less than 1 meter.
2. Excellent ventilation, set appropriate cooling method to ensure that the indoor ambient temperature is not higher than 40 °C. It is recommended to use the hot air duct method to dissipate heat. The exhaust volume of the exhaust fan needs to be larger than the air exhaust of the air conditioner cooling fan.
3. The relative humidity of the air is low, the dust is less, and there is no corrosive gas such as acid or alkali. If the air quality is lower than required, the suction port of the air compressor machine should be led to a place where the air is relatively clean, and the pre-filtering equipment may be added.
4. The air compressor should be placed on solid and flat ground to avoid oscillation of the compressor caused by the inclination of the ground. If the air compressor is placed on the upper floor, it is necessary to take certain vibration isolation measures.

The environment around the air compressor contains corrosive gases. For example, on some occasions, there will be sulfides, and cleaning chemicals will be emitted into the air. The high temperature of the machine itself accelerates the oxidation of the oil. Once these gases enter the air compressor system and chemically react with the oil, resulting in carbon deposits and sludge, some impurities enter the oil circulation system and are intercepted by the oil filter. As the oil and gas mixture rises to the oil content when the gas passes through the oil content, these impurities remain on the oil content filter paper, blocking the filter holes, and the resistance of the oil content slowly increases, so that the oil content needs to be replaced in a shorter time. Air filtration with poor filtration accuracy will prevent some of the dust particles in the air from being intercepted and entering the air compressor system directly. The load of the oil filter and the oil component is too large, causing the oil filter and the oil component to block prematurely. Excessive moisture on the oil content causes the filter material to swell and shrink the pores, reducing the effective separation area of ​​the oil content, resulting in increased resistance of the oil content and early clogging of the oil content.  Due to the simultaneous decrease of air pressure and temperature, the gas condenses into water droplets. The water droplets enter the oil content and make the filter material absorb water and swell and deteriorate.


 
Related News
Can air compressor lubricating oil be mixed?
Feb .20.2023
Can you mix lubricating oil? Many people think that there is no big problem with the mixed use of lubricating oil, but in actual cases, there are many problems caused by the hasty mixed use of lubricating oil, so it is very important to understand the kno
Top Ten Top Compressor Manufacturing Powers In The World
Oct .20.2022
Top Ten Top Compressor Manufacturing Powers In The World
Why Do Air Compressors Need Staged Compression? Can't You Compress It Once?
Oct .09.2022
Many people know that the two stages of the compressor are suitable for producing high pressure, and the first stage is suitable for producing large amount of air. Sometimes, you need to perform more than two compression operations. Why do you need to per